APW Wyott VCG Instruções de Operação descarregar pdf (Página 18)

Turn the screw counter clock-wise about a half turn. If the belt has walked over the right

sprocket, you will need to put it in the center of the sprockets by hand. CAUTION!!! THE

BELT MAY BE EXTREMELY HOT. YOU COULD BURN YOURSELF.

Yes

Did the belt walk

off the sprocket

in 5 minutes?

Did the belt walk

off the sprocket

in 5 minutes?

Has the belt

walked over

one of the

sprockets

within 10

minutes?

Start

END

Position yourself so that you face the conveyor with the access cover

between you and the conveyor. The platen should be on the other side

of the conveyor from you. This puts the adjustment screw on your right.

Continue to monitor the

conveyor from time-to-

time for a couple of days

to see if it walks over a

sprocket.

Did the conveyor

belt walk after a

few hours?

To which

sprocket did

the belt walk

over?

Left

Right

While conveyor

belt is still

between the

sprockets, turn the

screw 2 times

clock-wise.

While conveyor

belt is still

between the

sprockets, turn

the screw 2

times counter

clock-wise.

Within about 5

minutes, which

sprocket is the

conveyor walking

toward?

Turn the screw clock-

wise about a half turn. If

the belt has walked over

the right sprocket, you

will need to put it in the

center of the sprockets

by hand. CAUTION!!!

THE BELT MAY BE

EXTREMELY HOT. YOU

COULD BURN

YOURSELF.

Neither. It stays

in center.

TOOLS NEEDED: Needle-nose pliers, phillips-head screwdriver.

1. Turn off toaster. Let cool for 30 minutes.

2. Remove top lid and open front cover.

3. Turn toaster on and depress top lid switch button until the belt splice

(flap) is at about the center of the conveyor. Turn toaster off.

4. Remove the pin from the splice using the needle-nose pliers.

5. Remove the old belt from the toaster. (CAREFUL!!! MAY BE HOT! YOU

COULD BURN YOURSELF!)

6. Put the new belt on. Feed the belt through the conveyor using the end

of the belt without the flaps. (CAREFUL!!! MAY BE HOT! YOU

COULD BURN YOURSELF!)

7. Put pin in splice. Make sure sides of belt are aligned and that belt is

routed over the plastic roller. Make sure belt is in center of conveyor.

8. Close the front cover and turn to the rear conveyor.

9. Repeat steps 3-7 for rear conveyor.

10. Close the rear cover and replace the lid.

11. Turn toaster on and turn knobs to their normal settings.

12. Watch the conveyors to see if belts ride over the sprockets. If they do,

follow procedure for training a belt (see section 10, pages 17-18).

11. PROCEDURE FOR CHANGING A BELT

PROCEDURE FOR BELT ADJUSTMENT (TRACKING)

1 2 ... 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários

APW Wyott VCG Instruções de Operação Página 18

Comentários a estes Manuais

Manuais e produtos relacionados com Torradeiras APW Wyott VCG